D-Link DXS-3600-16S Manual page 628

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#peer backup 2.2.2.2
DXS-3600-32S(config-vpls)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#peer backup 2.2.2.2 100
DXS-3600-32S(config-vpls)#
67-7 xconnect vpls
This command is used to create a local AC in a VPLS. Use the no xconnect vpls command to delete a local AC in a
VPLS.
xconnect vpls VPLS-NAME
no xconnect vpls VPLS-NAME
Parameters
VPLS-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface GigabitEthernet 1/0/1
DXS-3600-32S(config-if)#xconnect vpls vpls100
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface GigabitEthernet 1/0/1
DXS-3600-32S(config)#encapsulation dot1q 100
DXS-3600-32S(config-subif)#xconnect vpls vpls100
DXS-3600-32S(config-subif)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to create a backup peer with the IP address of 2.2.2.2 and
VC ID is set by VPLS ID.
This example shows how to create a backup peer with the IP address of 2.2.2.2 and
VC ID of 100.
Specifies the VPLS name. This name can be up to 32 characters long.
None.
Interface Configuration Mode (Ethernet Interface or Ethernet VLAN Interface Mode).
Level: 15.
This command is used to create a local AC in a VPLS. A local AC could be an
Ethernet-based AC, which is created in an Ethernet interface, or an Ethernet VLAN-
based AC, which is created in Ethernet VLAN interface. All local ACs in a VPLS
should have same AC type.
This example shows how to create a local AC, which is an Ethernet-based AC and
the Ethernet port is 1/0/1, into a VPLS with the name of vpls100.
This example shows how to create a local AC, which is an Ethernet VLAN-based
AC, the Ethernet port is 1/0/1, and the VLAN is 100, into a VPLS with the name of
vpls100.
620