Show Ip Bgp Parameters - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show ip bgp route-map vrf 100 map1
BGP Local Router ID is 11.11.11.11
Status codes: s suppressed, d damped, h history, * valid, > best, i - internal
Origin codes: i - IGP, e - EGP, ? - incomplete
IP Address/Netmask
Route Distinguisher: 1:100 (default for VRF 100)
*> 56.1.1.0/24
*> 56.1.2.0/24
*> 56.1.3.0/24
DXS-3600-32S#
Display Parameters
BGP Local Router ID
Status codes
Origin codes
IP Address/Netmask
Gateway
Metric
LocPrf
Weight
Path

7-87 show ip bgp parameters

This command is used to display parameters of the Border Gateway Protocol.
show ip bgp parameters
Parameters
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The following example displays routes that match the route-map map1 in VRF 100.
Gateway
50.1.1.10
50.1.1.10
50.1.1.10
Description
The router identifier of the local BGP router.
Status of the table entry displayed at the beginning of each line. It can be one or
more of the following values:
s - The table entry is suppressed.
d - The table entry is damped.
h - The table entry is damped and has been withdrawn by the neighbor.
* - The table entry is valid.
> - The table entry is the best entry to use for that network.
i - The table entry was learned via an internal BGP (iBGP) session.
Origin of the table entry displayed at the end of each line. It can be one of the
following values:
i - Entry originated from an Interior Gateway Protocol (IGP) and was advertised
with a network router configuration command.
e - Entry originated from an Exterior Gateway Protocol (EGP).
? - Origin of the path is not clear. Usually, this is a router that is redistributed into
BGP from an IGP.
IP prefix with its mask length of the entry.
IP address of the next router that is used when forwarding a packet to the destination
network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to
this network.
If shown, this is the value of the inter-autonomous system metric. This field is
frequently not used.
Local preference value as set with the set local-preference route-map configuration
command. The default value is 100.
Weight of the route as set via autonomous system filters.
Autonomous system paths to the destination network.
None.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
Metric LocPrf
0 0
0 0
0 0
150
Weight Path
10 i
10 i
10 i