Dot1X Reauthentication - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#dot1x timeout quiet-period 20
DXS-3600-32S(config-if)#dot1x timeout reauth-period 1000
DXS-3600-32S(config-if)#dot1x timeout server-timeout 15
DXS-3600-32S(config-if)#dot1x timeout supp-timeout 15
DXS-3600-32S(config-if)#dot1x timeout tx-period 10
DXS-3600-32S(config-if)#
2-6 dot1x max-req
This command is used to configure the maximum number of times that the backend authentication state machine will
retransmit an Extensible Authentication Protocol (EAP) request frame to the supplicant before restarting the
authentication process. Use the no form of this command to reset the maximum number of times to its default value.
dot1x max-req <int 1-10>
no dot1x max-req
Parameters
max-req <int 1-10>
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#dot1x max-req 3
DXS-3600-32S(config-if)#

2-7 dot1x reauthentication

This command is used to enable periodic reauthentication. Use the no form of this command to return to disable
periodic reuthentication.
dot1x reauthentication
no dot1x reauthentication
Parameters
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the quiet period, reauthentication period,
server timeout value, supplicant timeout value, and transmission period for Ethernet
port 1 to be 20, 1000, 15, 15, and 10 seconds, respectively.
Number of times that the switch retransmits an EAP frame to the supplicant before
restarting the authentication process. The range is 1 to 10.
The default value is 2 times.
Interface Configuration Mode.
Level: 8
This command is used to set the maximum number of times that the backend
authentication state machine will retransmit an Extensible Authentication Protocol
(EAP) request frame to the supplicant before restarting the authentication process.
This example shows how to set the maximum number of retries allowed on port 1.
The maximum number of retries is set to 3.
None.
The periodic reauthentication on interface is disabled by default.
Interface Configuration Mode.
Level: 8
9