Match Metric - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip standard access-list LocalServer
DXS-3600-32S(config-ip-acl)#permit 172.19.10.1/32
DXS-3600-32S(config-ip-acl)#exit
DXS-3600-32S(config)#route-map rmap1 permit 10
DXS-3600-32S(config-route-map)#match ip route-source LocalServer
DXS-3600-32S(config-route-map)#

53-9 match metric

This command is used to add a match command to match the metric of routes. Use the no form of this command to
delete the match command with metric of routes.
match metric NUMBER
no match metric
Parameters
NUMBER
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map rmap1 permit 10
DXS-3600-32S(config-route-map)#match metric 5
DXS-3600-32S(config-route-map)#
53-10 match route-type
This command is used to add a match command to match the type of routes. Use the no form of this command to
delete the match command with type of routes.
match route-type {internal | external | type-1 | type-2}
no match route-type
Parameters
internal
external
type-1
type-2
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to add a match command to match source router IP
address of routes using standard IP access list.
Specifies the metric of routes. The range is 0 to 4294967294.
None.
Route Map Configuration Mode.
Level: 8
You can verify your settings by entering the show route-map command.
This example shows how to add a match command to match the metric of routes.
Specifies the Intra-area and inter-area routes of Open Shortest Path First (OSPF).
Specifies the Autonomous System external route of OSPF, including type-1 and
type-2 external routes.
Specifies the Type-1 external route of OSPF
Specifies the Type-2 external route of OSPF
None.
Route Map Configuration Mode.
Level: 8
528