Password Recovery Commands - D-Link DXS-3600-16S Manual

Password Recovery Commands

The first two commands, listed in this chapter, are only available when the user enters the Password Recovery mode.
For more information about how to access the Password Recovery mode, see
Procedure" on page 664.
41-1 clear
This command is used to clear the password, username or password on the current device.
clear {levelpassword | username | configure}
Parameters
levelpassword
username
configure
Default
Command Mode
Command Default Level
Usage Guideline
Example
>clear configure
>
Example
>clear levelpassword
>
Example
>clear username
>
41-2 reload
This command is used to reboot the switch.
reload
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to clear the password for each level.
Specifies to clear all the usernames and passwords on the device and set the line
authentication to no login local, no login, and no login authentication at the same
time.
Specifies to clear all the configurations on the DUT.
None.
EXEC Mode in Password Recovery Mode.
Level: 1
When the password is lost, or the username information is lost, the user can enter
the password recovery mode and use this command to clear the level, clear the
username or clear the configuration.
This example shows how to clear the configuration to factory default settings.
This example shows how to clear the level password to factory default settings.
This example shows how to clear the local authentication database to factory default
settings.
None.
None.
EXEC Mode in Password Recover Mode.
Level: 1
Used to reboot the switch.
"Appendix A - Password Recovery
417