D-Link DXS-3600-16S Manual page 471

Example
DXS-3600-32S#show ip pim sparse-mode rp mapping
Group(s): 229.1.3.0/28
RP: 10.2.0.2
via bootstrap, priority 192, RP hold time: 150
Uptime: 00:17:37, expires: 00:01:52
Group(s): 229.1.5.16/28
RP: 10.90.90.90
via bootstrap, priority 192, RP hold time: 150
Uptime: 00:16:54, expires: 00:01:36
Group(s): 231.0.0.0/8
RP: 10.90.90.90
via bootstrap, priority 192, RP hold time: 150
Uptime: 00:16:54, expires: 00:01:36
Group(s): 233.0.0.0/8
RP: 10.90.90.90
via bootstrap, priority 192, RP hold time: 150
Uptime: 00:16:54, expires: 00:01:36
Group(s): 239.0.0.0/11, static
RP: 172.18.254.1
DXS-3600-32S#
Display Parameters
Groups
RP
RP hold time
static
expires
Uptime
47-18 show ip pim sparse-mode rp-hash
This command is used to display which rendezvous point is being selected for a specified group.
show ip pim sparse-mode rp-hash GROUP-ADDRESS
Parameters
GROUP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example displays PIM-SM RP mapping information.
Description
Group range mapping to the RP below.
Address of the rendezvous point for that group.
Hold time of the RP.
Group-to-mapping information from the static rendezvous-point configuration. Create
by command ip pim rp-address.
Time (in hours, minutes, and seconds) after which the information about candidate
RP entry expires. If the router does not receive any refresh messages in this time, it
discards information.
Length of time (in hours, minutes, and seconds) that the router has known about this
rendezvous point.
Specifies the rendezvous point information for the specified group address.
None.
Privileged EXEC Mode.
Level: 3. (EI Mode Only Command)
This command displays which rendezvous point was selected for the group
specified. It also shows whether this rendezvous point was selected by the PIM
Version 2 bootstrap mechanism or manually configured.
463