Routing Information Protocol (Rip) Commands - D-Link DXS-3600-16S Manual

Routing Information Protocol (RIP) Commands

52-1 route-preference
This command is used to configure the route preference for the Routing Information Protocol (RIP) routes. Use the no
form of this command to restore to the default value.
route-preference value
no route-preference
Parameters
value
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router rip
DXS-3600-32S(config-router)#route-preference 120
DXS-3600-32S(config-router)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router rip
DXS-3600-32S(config-router)#no route-preference
DXS-3600-32S(config-router)#
Example
DXS-3600-32S# configure terminal
DXS-3600-32S(config)# router rip
DXS-3600-32S(config)# address-family ipv4 vrf VPN-A
DXS-3600-32S(config-router-af)# route-preference 120
52-2 distribute-list in (RIP)
This command is used to filter RIP routes inserted into routing table. Use the no form of this command to remove the
setting.
distribute-list list_name in ipif_name
no distribute-list list_name in ipif_name
Parameters
list_name
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the route preference of the RIP route. The value range is 1-999.
The default value of route preference of RIP route is 100.
Router Configuration Mode.
Router Address Family Configuration Mode.
Level: 8. (EI Mode Only Command)
This command sets the route preference of the RIP routes. A route preference is a
rating of the trustworthiness of a routing information source, such as an individual
router or a group of routers. In general, the higher the value, the lower the trust rating
is.
You can verify your settings by entering the show ip route-preference command.
This example shows how to set the route preference of RIP routes to 120.
This example shows how to restore the route preference of RIP route to default
value.
This example shows how to set the route preference of RIP routes to 120 of RIP
VRF VPN-A instance.
Specifies the name of the standard IP access list.
508