Virtual Private Lan Service (Vpls) Commands - D-Link DXS-3600-16S Manual

Virtual Private LAN Service (VPLS) Commands

67-1 vpls
This command is used to create a VPLS and enter the VPLS configuration mode. Use the no vpls command to delete
a VPLS.
vpls VPLS-NAME
no vpls VPLS-NAME
Parameters
VPLS-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no vpls vpls100
DXS-3600-32S(config)#
67-2 vpls-id
This command is used to set the VPLS ID of a VPLS.
vpls-id VPLS-ID
Parameters
VPLS-ID
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the VPLS name. This name can be up to 32 characters long.
No VPLS created.
Global Configuration Mode.
Level: 3.
This command is used to create a VPLS and enter the VPLS configuration mode. If
that VPLS already exists, this command will skip the creation and directly enter the
VPLS configuration mode. The VPLS name is used to locally identify a unique VPLS
in a device.
This example show how to create a VPLS with the name of vpls100 and enter the
VPLS configuration mode.
This example shows how to delete a VPLS with the name of vpls100.
Specifies the VPLS ID of a VPLS. This value must be between 1 and 4294967295.
The VPLS ID is used as the VC ID of the pseudowires in the VPLS, which do not
have a specified VC ID.
0.
VPLS Configuration Mode.
Level: 15.
This command is used to set the VPLS ID of a VPLS in VPLS configuration mode.
Each VPLS in a device should have a local unique VPLS ID.
616