D-Link DXS-3600-16S Manual page 520

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip rip receive version 1 2
DXS-3600-32S(config-if)#
52-7 ip rip send enable
This command is used to send RIP packets on a RIP interface. Use the no form of this command to prohibit sending
RIP packets on the interface.
ip rip send enable
no ip rip send enable
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no ip rip send enable
DXS-3600-32S(config-if)#
52-8 ip rip send version
This command is used to specify the version of RIP packets sent on a RIP interface. Use the no form of this command
to restore to the default value.
ip rip send version {1 | 2}
no ip rip send version
Parameters
1
2
Default
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the interface 'vlan1' to receive both RIP
version 1 and version 2 packets.
None.
By defaul, the sending of RIP packets is enabled on the RIP interface.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
Use the no form of this command to prevent from sending RIP packets on the
interface, the RIP protocol should not send out RIP packets.
On one interface whose receiving packets is disabled or Version 1, disabling sending
packets will cause the configuration of authentication on this interface to be cleared
and can't be restored when enable interface sending packets again. The
authentication needs to be reconfigured.
With the no form of this command, the configuration set by ip rip send version
command will be cleared. After enable interface sending packets again, the send
version of the interface depends on global version setting with the version
command.
This example shows how to configure the interface 'vlan1' to not send out RIP
packets.
(Optional) Specifies to send only RIP Version 1 packets out the interface.
(Optional) Specifies to send only RIP Version 2 packets out the interface.
None.
512

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents