Logging Buffered - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show logging
Syslog Logging: Enabled
Console Logging: Level Informational
Buffer Logging: Level Debugging
Trap Logging: Level Informational
Facility: local1
logging to 10.90.90.4
Logging File Write Delay: On_demand
Syslog Source IP Interface Configuration:
IP Interface : vlan1
IPv4 Address : 192.168.69.123
DXS-3600-32S#
60-10 show logging count
This command is used to show the log statistics.
show logging count
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show logging count
Total logging Count: 0
DXS-3600-32S#

60-11 logging buffered

This command is used to set the memory buffer parameters for logs. The no form of the command disables recording
logs in memory buffer.
logging buffered [LEVEL] | [write-delay {SECONDS | INFINITE}]
no logging buffered
Parameters
LEVEL
SECONDS
INFINITE
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows the result of the show logging command.
None.
None.
EXEC Mode.
Level: 15
To use the log packet statistics function, run logging count in the global configuration
mode. The show logging count can show the information of a log.
This example shows the log statistics.
Specifies the severity of log messages, 0 to 7. The name of the severity or the
numeral can be used.
Specifies the minutes interval to write logs in the flash.
Specifies that the logs are not recorded in the flash.
Default level : Debugging(7).
Default will log to buffer and disable periodical writing of the logging buffer to FLASH.
Global Configuration Mode.
Level: 15
589