Configuration Commands - D-Link DXS-3600-16S Manual

Configuration Commands

9-1 show running-config
This command is used to show the configuration information of the current device's system running.
show running-config
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show running-config
Building configuration...
Current configuration : 108272 bytes
#-------------------------------------------------------------------------------
#
#
#
#
# Copyright(C) 2012 D-Link Corporation. All rights reserved.
#-------------------------------------------------------------------------------
# DEVICE
configure terminal
logging-server enable device
end
# PRIVMGMT
configure terminal
9-2 show bootup-config
This command is used to view the boot-up configuration of the device, stored in the Non-volatile Random Access
Memory (NVRAM).
show bootup-config
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
None.
Privileged Mode.
Level: 15
This command is used to display the complete configuration information of the
current device's system running.
This example shows how the configuration information of the current device's
configuration system running. The field descriptions are self-explanatory.
DXS-3600-32S TenGigabit Ethernet Switch
Configuration
Firmware: Build 1.10.023
<The Output is Truncated>
None.
None.
Privileged Mode.
Level: 15
This command is used to display the boot-up configuration of the device, stored in
the NVRAM. The boot-up configuration can be changed by boot config command in
global configuration mode.
175