Mirror Commands - D-Link DXS-3600-16S Manual

Mirror Commands

36-1 monitor session
This command is used to monitor a session, create a mirror session, and to specify the destination port or source port.
The no form of the command is used to delete the whole session or delete the source port, destination port, acl mirror
separately.
monitor session session_number {source interface {port-group GROUP-ID | INTERFACE-ID [,|-]} [{both | rx |
tx}] |
destination interface {port-group GROUP-ID | INTERFACE-ID [,|-]} [acl name]}
no monitor session session_number [{source interface {port-group GROUP-ID | INTERFACE-ID [,|-]} [,|-]
[{both | rx | tx}] |
destination interface {port-group GROUP-ID | INTERFACE-ID [,|-]} [acl name]}]
Parameters
session_number
source
interface INTERFACE-ID
port-group GROUP-ID
,
-
both
rx
tx
destination
interface interface-id
acl
name
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the mirror session number.
Specifies the source port interface.
Specifies the physical interface ID used.
Specifies the port group ID.
(Optional) Specifies a series of physical interfaces. No space before and after the
comma.
(Optional) Specifies a range of physical interfaces. No space before and after the
hyphen.
Specifies to monitor the inbound and outbound frames simultaneously.
Specifies to monitor only the inbound frames.
Specifies to monitor only the outbound frames.
Specifies the destination port, it can be one physical or a trunk member interface.
Specifies the physical interface ID used.
Specifies the flow-based mirror. Only the ingress mirror is supported.
Specifies the ACL name for the monitor session. If the ACL does not exist, then the
flow-based mirror cannot be set.
No monitoring session.
Global Configuration Mode.
Level: 12
The command can be used to mirror all the packets received or sent at a port to
another port for analysis. The valid interfaces for this command are physical port or
trunk member port.
The user can configure one or multiple mirror session, the mirror function does not
affect the normal operation of the switch. You can configure a mirror session on
disabled ports. However, the mirror does not work unless you enable the source and
destination ports.
A port can not be configured as the source port and the destination port at the same
time, the source and destination port can reside in the same VLAN or different
VLANs. For each mirror session, source interface can be many ports, but destination
interface can be a physical port or logical port.
338