Ip Vrf Forwarding - D-Link DXS-3600-16S Manual

6-24 ip vrf forwarding

This command is used to configure the Virtual Private Network (VPN) routing and forwarding (VRF) reference of an
authentication, authorization, and accounting (AAA) RADIUS or TACACS+ server group. Use this command in the
server-group configuration mode. To enable server groups to use the global (default) routing table, use the no form of
this command.
ip vrf forwarding vrf-name
no ip vrf forwarding
Parameters
vrf-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#aaa group server radius sg_global
DXS-3600-32S(config-aaa-groug-server)#server-private 172.16.010.0254 timeout 5 retransmit 3
DXS-3600-32S(config-aaa-groug-server)#exit
DXS-3600-32S(config)#
DXS-3600-32S(config)#aaa group server radius sg_water
DXS-3600-32S(config-aaa-group-server)#server-private 10.10.0.01 timeout 5 retransmit 3 key water
DXS-3600-32S(config-aaa-group-server)#ip vrf forwarding water
DXS-3600-32S(config-aaa-group-server)#end
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name assigned to a VRF.
No server is configured.
Server Group Configuration Mode.
Level: 15
Use this command to specify a VRF for an AAA RADIUS or TACACS+ server group.
This command enables dial access users to utilize AAA servers in different routing
domains.
The following example shows how to configure the VRF user to reference the
RADIUS server in a different VRF server group:
64