D-Link DXS-3600-16S Manual page 438

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport port-security aging time 8
DXS-3600-32S(config-if)#switchport port-security aging type absolute
DXS-3600-32S(config-if)#switchport port-security aging static
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no switchport port-security aging static
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no switchport port-security aging type
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no switchport port-security aging time
DXS-3600-32S(config-if)#
44-3 switchport port-security mac-address
This command is used to configure the secure address table. Use the no form of the command to delete the configured
address or sticky address of this interface.
switchport port-security [{mac-address <mac-address> [vlan <vlan-id>] | mac-address sticky [<mac-address>
[vlan <vlan-id>]]}] [maximum <value 1-12288>]
no switchport port-security [{mac-address <mac-address> [vlan <vlan-id>] | mac-address sticky [<mac-
address> [vlan <vlan-id>]]}] [maximum]
Parameters
mac-address mac-address Specifies to set the secure MAC address of the port.
mac-address sticky mac-
address
vlan vlan-id
maximum
Default
Command Mode
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the aging time and type for the manually
configured secure address and automatically learnt addresses on interface
tenGigabitEthernet 1/0/1.
This example shows how to apply the aging time only for automatically learnt secure
MAC addresses for interface tenGigabitEthernet 1/0/1.
This example shows how to recover the port security aging time type for interface
tenGigabitEthernet 1/0/1.
This example shows how to disable the port security aging time for interface
tenGigabitEthernet 1/0/1.
Specifies to set secure sticky MAC address of the port. These addresses can be
dynamically learned or manually configured.
Specifies, except an access port, the VLAN ID and the MAC address. If no VLAN ID
is specified, the native VLAN is used.
Specifies to set the maximum number of the addresses in the secure address table.
The range is from 1 to 12288.
Not set any secure MAC address.
The default of maximum is 128.
The default of sticky address is disabled.
Interface Configuration Mode.
430