48-17 show class-map
This command is used to display the quality of service (QoS) class maps, which define the match criteria to classify
traffic.
show class-map [class-map-name]
Parameters
class-map-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show class-map
Class Map class1
Match access-group 101
Class Map class2
Match access-group 8
DXS-3600-32S#
48-18 show mls qos interface
This command is used to display the QoS configuration on the interface.
show mls qos interface [INTERFACE-ID [,|-]] [policers]
Parameters
INTERFACE-ID [,|-]
policers
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name of the class for the class map. The name can be a maximum of
32 alphanumeric characters.
None.
Privileged EXEC Mode.
Level: 15
If the class map name is not specified, all class map information will be displayed.
This example shows the output from the show class-map command.
Specifies the interface ID for which the QoS configure information will be displayed.
You can specify multiple interface IDs, which are separated by commas (,) or
hyphens (-). No space is before or after the commas or hyphens.
Specifies to only show the police associated with specify interface.
None.
Privileged EXEC Mode.
Level: 15
If no interface ID is specified, all interfaces QoS information will be display. If the key
policers is specified, just the policy map information of the specified interface will be
displayed.
480