D-Link DXS-3600-16S Manual page 478

Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#mls qos map dscp-cos 12,16,18 to 1
DXS-3600-32S(config)#
48-6 mls qos scheduler
This command is used to configure the queue scheduling algorithm in global configuration mode. To restore to the
default setting, use the no form of this command.
mls qos scheduler [sp | rr | wrr | wdrr | ets]
no mls qos scheduler
Parameters
sp
rr
wrr
wdrr
ets
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#mls qos scheduler sp
DXS-3600-32S(config-if)#
48-7 mls qos trust
This command is used to trust either the CoS field or the DSCP field of the arriving packet for subsequent QoS
operation. Use the no form of this command to restore it to default setting.
mls qos trust {cos | dscp}
no mls qos trust
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The DSCP to CoS map is used by a DSCP trust port to map a DSCP value to an
CoS value. This CoS value is then mapped to CoS queue based on the CoS to
queue map configured by the priority-queue cos-map command.
This example shows how to configure the DSCP 12, 16, 18 to CoS 1 mapping.
Specifies all queues of a port in absolute priority scheduling.
Specifies all queues of a port in round-robin scheduling.
Specifies the queues of a port in frame count weighted round-robin scheduling. If the
weight of a queue be configured to zero, the queue is in SP scheduling mode.
Specifies the queues of a port in frame length weighted round-robin scheduling. If
the weight of a queue be configured to zero, the queue is in SP scheduling mode.
Specifies the queues of a port in ETS weighted round-robin scheduling.
WRR queue scheduling algorithm.
Global Configuration Mode.
Level: 15
The user can specify schedule algorithms to WRR, SP, RR or WDRR for the output
queue. By default, the output queue algorithm is WRR (Weighted Round-Robin).
The user may specify the WRR weight by using the wrr-queue bandwidth
command and specify the WDRR weight by using the wdrr-queue bandwidth
command.
The user can also specify the "SP + WRR/WDRR" scheduling mode by configuring
the WRR/WDRR weight of a queue to zero.
This example shows how to configure the queue scheduling algorithm mode.
470