D-Link DXS-3600-16S Manual page 579

57-23 show spanning-tree interface
This command is used to show the STP configuration of the interface.
show spanning-tree interface INTERFACE-ID [{portfast | link-type}]
Parameters
interface INTERFACE-ID
portfast
link-type
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show spanning-tree interface tenGigabitEthernet 1/0/1
PortAdminExternalCost : 22
operExternalPortPathCost : 200000
PortAdminPortFast : Disabled
PortAutoEdge : Enabled
PortOperPortFast : Disabled
PortAdminLinkType : point-to-point
PortOperP2PLinkType : point-to-point
PortRootGuard : Enabled
PortTcGuard : Enabled
###### MST 0 vlans mapped : 1-4094
PortState : Disabled
PortPriority : 128
PortDesignatedRoot :
PortDesignatedCost :
PortDesignatedBridge :
PortDesignatedPort :
PortAdminInternalCost :
PortOperInternalCost :
PortRole : Disabled
DXS-3600-32S#
Example
DXS-3600-32S#show spanning-tree interface tenGigabitEthernet 1/0/1 portfast
PortAdminPortFast : Disabled
PortOperPortFast : Disabled
PortAdminAutoEdge : Enabled
PortOperAutoEdge : Disabled
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Displays the STP interface information.
Displays the STP interface's portfast information
Displays the STP interface's link-type information.
None.
EXEC Mode.
Level: 3
Show the STP configuration of the interface.
This example shows the port information.
0000.0000.0000.0000
0
0000.0000.0000.0000
0
32
200000
This example shows the port information about portfast.
571