D-Link DXS-3600-16S Manual page 81

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

7-14 bgp confederation identifier
This command is used to specify the BGP confederation identifier. Use the no form of this command to remove the
confederation identifier.
bgp confederation identifier AS-NUMBER
no bgp confederation identifier
Parameters
AS-NUMBER
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router bgp 100
DXS-3600-32S(config-router)#bgp confederation identifier 20
DXS-3600-32S(config-router)#
7-15 bgp confederation peers
This command is used to add BGP confederation peers. Use the no form of this command to delete the confederation
peers.
bgp confederation peers ASPATH-LIST
no bgp confederation peers ASPATH-LIST
Parameters
ASPATH-LIST
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the Autonomous System number, used to specify the BGP confederation.
This value must be between 1 and 4294967295. The AS TRANS value is 23456.
None.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
A confederation can be used to reduce the internal BGP (iBGP) mesh by dividing a
large single AS into multiple subs-ASs. External peers interact with the
confederation as if it is a single AS.
Each subs-AS is fully meshed within itself and it has connections to other sub-ASs
within the confederation. The next-hop, Multi Exit Discriminator (MED), and local
preference information is preserved throughout the confederation, allowing users to
retain a single Interior Gateway Protocol (IGP) for all the autonomous systems.
Use the show ip bgp confederation command to verify your settings.
This example shows how to create a confederation in which the AS number is 20.
Specifies one or multiple AS number partitions, separated by a comma. This value
must be between 1 and 4294967295, however, for the AS TRANS, this value must
be 23456. This parameter specifies Autonomous System numbers for BGP peers
that will belong to the confederation.
None.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
73

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents