D-Link DXS-3600-16S Manual page 208

Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp relay information option82
DXS-3600-32S(config)#
13-4 ip dhcp relay option60
This command is used to enable the DHCP relay Option 60 function. The no form of this command is used to disable
the DHCP relay Option 60 function.
ip dhcp relay option60
no ip dhcp relay option60
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip dhcp relay option60
DXS-3600-32S(config)#
13-5 ip dhcp relay option60 identifier
This command is used to add a DHCP server IP address for a specific Option 60. The no form of this command deletes
the DHCP server IP address for that Option 60.
ip dhcp relay option60 identifier desc 255 relay ip-address [exact-match | partial-match]
no ip dhcp relay option60 identifier desc 255
Parameters
desc 255
ip-address
exact-match
partial-match
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default, this option is disabled.
Global Configuration Mode.
Level: 8
When DHCP Option 82 is enabled, the DHCP packet received from the client will be
inserted with and Option 82 field before being relayed to the server. The DHCP
Option 82 containes 2 sub-options which are circuit ID sub-option and remote ID
sub-option.
This example shows how to enable the ip dhcp relay information option82
function.
None.
By default, this option is disabled.
Global Configuration Mode.
Level: 8
When Option 60 is enabled, if the packet contains Option 60, it will be based on the
Option 60 field to determine the relay server. You can verify your settings by entering
the show ip dhcp relay option60 command.
This example shows how to enable the DHCP relay Option 60 function.
Specifies the specified string.
Specifies the IP address of the DHCP server.
Specifies that the DHCP client string needs to exactly match the specified string.
Specifies that the DHCP client string only needs to partially match the specified
string.
200