D-Link DXS-3600-16S Manual page 41

name
in
out
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/2
DXS-3600-32S(config-if)#expert access-group exp_acl in
DXS-3600-32S(config-if)#end
DXS-3600-32S#show access-group interface tenGigabitEthernet 1/0/2
Interface tenGigabitEthernet 1/0/2:
expert access-group exp_acl in
DXS-3600-32S#
3-18 show access-group
This command is used to display the ACL configuration of the interface.
show access-group [interface interface]
Parameters
interface interface
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name of the expert ACL to be configured. The name can be up to 32
characters long.
Specifies to filter the incoming packets of the interface.
Specifies to filter the outgoing packets of the interface.
None.
Interface Configuration Mode.
Level: 12
Only one expert ACL can be attached to an ingress physical port or egress physical
port.
Applying or binding an ACL to an interface will fail if there is any criteria statements
that are not supported. An error message "Do not support fields: ..." will be displayed
and all unsupported criteria statements of the ACL type will be listed.
This example shows how to apply an expert ACL to an interface. The purpose is to
apply the ACL 'exp_acl' attribute to the tenGigabitEthernet 1/0/2 interface, to filter
incoming packets.
Specifies the interface ID used.
None.
EXEC Mode.
Level: 1
Displays the ACL applied to the interface. If no interface is specified, the ACLs
applied to all the interfaces will be displayed.
33