D-Link DXS-3600-16S Manual page 111

7-50 neighbor remote-as
This command is used to create a BGP neighbor with its remote AS or configure the remote AS of a peer group. Use
the no form of this command to delete a neighbor or a peer group.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} remote-as AS-NUMBER
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} remote-as
Parameters
IP-ADDRESS
PEER-GROUP-NAME
AS-NUMBER
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router bgp 40000
DXS-3600-32S(config-router)#neighbor 10.10.10.2 remote-as 10
DXS-3600-32S(config-router)#
7-51 neighbor remove-private-as
This command is used to remove private autonomous system numbers from the autonomous system path attribute in
the updates sent to the specified neighbor or the members of the specified peer group. To disable this function, use the
no form of this command.
neighbor {IP-ADDRESS | PEER-GROUP-NAME} remove-private-as
no neighbor {IP-ADDRESS | PEER-GROUP-NAME} remove-private-as
Parameters
IP-ADDRESS
PEER-GROUP-NAME
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the IP address of the BGP peer.
Specifies the name of a Border Gateway Protocol (BGP) peer group. The maximum
length is 16 characters.
Specifies the number of autonomous system to which the neighbor belongs. Range
for 2-byte numbers is 1 to 65535. Range for 4-byte numbers is 1 to 4294967295.
There are no BGP neighbor peers.
Router Configuration Mode.
Address Family Configuration Mode (VRF).
Level: 8. (EI Mode Only Command)
If you specify a BGP peer group, all the members of the peer group will inherit the
characteristic configured with this command. When using the no form of this
command with PEER-GROUP parameter, all the members that are generated with
no indicated AS number will be deleted.
Use the show ip bgp neighbors or show ip bgp peer-group command to verify
your settings.
This example shows how to create a neighbor 10.10.10.2 with remote AS 10.
Specifies the IP address of the BGP peer.
Specifies the name of a Border Gateway Protocol (BGP) peer group. The maximum
length is 16 characters.
By default, this option is disabled.
Router Configuration Mode.
Address Family Configuration Mode (IPv4 Unicast and VRF).
Level: 8. (EI Mode Only Command)
103