Telnet Commands - D-Link DXS-3600-16S Manual

TELNET Commands

62-1 ip telnet server enable
This command is used to enable the TELNET server on the switch. Use the no form of this command to disable the
TELNET server on the switch.
ip telnet server enable
no ip telnet server enable
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip telnet server enable
DXS-3600-32S(config)#
62-2 telnet
This command is used to TELNET to a remote server and manage it through the TELNET protocol.
telnet <ip-address> [port]
telnet [vrf <string 1-12>] <ip-address> [port]
Parameters
vrf <string 1-12>
ip-address
port
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#telnet 10.90.90.91
62-3 show ip telnet server
This command is used to display the TELNET server information.
show ip telnet server
Parameters
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
By default the TELNET server is enabled.
Global Configure Mode.
Level: 8
This command enables the TELNET server service on the switch. It allows
communication with and management of the switch using the TELNET protocol.
This example shows how to enable the TELNET server on the switch.
Specifies the VRF of the TELNET server. If the parameter is not specified, it
indicates the global routing forward space.
Specifies the IPv4 address of the destination end station.
Specifies the TCP port number of the TELNET server.
None.
Privileged EXEC Mode.
Level: 2
This command is used to TELNET to a remove server and manage it through the
TELNET protocol
This example shows how to TELNET to a remove server.
None.
595