D-Link DXS-3600-16S Manual page 583

58-2 storm-control action
This command is used to enable the specified action. Use the no form of this command to configure this option to the
default settings.
storm-control action {block | shutdown | drop}
no storm-control action
Parameters
block
shutdown
drop
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#storm-control action shutdown
Success
DXS-3600-32S(config-if)#
58-3 storm-control interval
This command is used to configure the interval time. Use the no form of the command to default time
storm-control interval <sec 1-300>
no storm-control interval
Parameters
interval <sec 1-300>
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the storm-control block the flooding of which storm packets when the
value specified for rise threshold is reached, and recover the flooding of which storm
packets when the value specified for low threshold is falling.
Specifies the storm-control to shutdown the port when the value specified for rise
threshold is reached.
Specifies the storm-control discard packets that exceed the rise threshold
The default setting of the action is block storm packets.
Interface Configuration Mode.
Level: 15
If the port shutdown, you must use the no storm-control action or the no storm-
control {broadcast | multicast | unicast} commands to recover the port.
This example shows how to enable the shutdown action on port 1.
Specifies the time interval that the switch checks the storm. The range of 1 to 300 in
seconds.
The default interval time is 5s.
Global Configuration Mode.
Level: 15
In order to maintain the stability of network state, it is recommended to set the time
interval of not less than the default value.
575