D-Link DXS-3600-16S Manual page 323

Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lldp receive
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no lldp receive
DXS-3600-32S(config-if)#
32-12 lldp tlv-select
This command is used to specify which optional type-length-value settings (TLVs) in the 802.1AB basic management
set will be transmitted and encapsulated in the LLDPDUs and sent to neighbor devices. To disable transmit the TLVs,
use the no form of this command.
lldp tlv-select [port-description | system-capabilities | system-description | system-name | mac-phy-cfg]
no lldp tlv-select [port-description | system-capabilities | system-description | system-name | mac-phy-cfg]
Parameters
port-description
system-capabilities
system-description
system-name
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#lldp tlv-select system-name
DXS-3600-32S(config-if)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
LLDP is enabled on all supported interfaces.
Interface Configuration Mode.
Level: 12
None.
This example shows how to enable the receive state.
This example shows how to disable the receive state.
Specifies the Port Description TLV to send or receive. The Port Description TLV
allows network management to advertise the IEEE 802 LAN station's port
description.
Specifies the System Capabilities TLV to send or receive. The System Capabilities
field shall contain a bit-map of the capabilities that define the primary function(s) of
the system.
Specifies the System Description TLV to send or receive. The System Description
should include the full name and version identification of the system's hardware type,
software operating system, and networking software.
Specifies the System Name TLV to send or receive. The System Name should be
the system's fully qualified domain name.
No 802.1AB basic management TLV is selected.
Interface Configuration Mode.
Level: 12
This command specifies the optional TLVs advertisement settings. If the optional
TLVs advertisement state enabled, they will be encapsulated in LLDPDU and sent to
other devices.
This example shows how to enable System Name TLV advertisement.
315