D-Link DXS-3600-16S Manual page 432

half
auto
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#duplex full
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no duplex
DXS-3600-32S(config-if-range)#
43-7 flowcontrol
This command is used to specify the flow control.
flowcontrol {auto | on | off}
no flowcontrol
Parameters
auto
on
off
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#flowcontrol on
DXS-3600-32S(config-if)#exit
DXS-3600-32S(config)#interface range tenGigabitEthernet 1/0/1-1/0/10
DXS-3600-32S(config-if-range)#no flowcontrol
DXS-3600-32S(config-if-range)#
43-8 mtu
This command is used to specify the Maximum Transmission Unit (MTU) of the port.
mtu <64-12288>
no mtu
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies that the communication system will be set to half-duplex.
Specifies that the communication system will be set to auto-negotiation.
None.
Port Configuration Mode.
Level: 15
None.
This example shows how to set the communication system for a port.
Specifies that the flow control will be set to auto-negotiate.
Specifies that the flow control option will be enabled.
Specifies that the flow control option will be disabled.
By default, this option is set to auto.
Port Configuration Mode.
Level: 15
None.
This example shows how to specify the flow control.
424