D-Link DXS-3600-16S Manual page 268

ip igmp robustness-variable number
no ip igmp robustness-variable
Parameters
number
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip igmp robustness-variable 3
DXS-3600-32S(config-if)#
23-7 ip igmp version
This command is used to set the version number of IGMP to be used on the interface. Use the no form of this
command to restore it to the default value.
ip igmp version {1 | 2 | 3}
no ip igmp version
Parameters
{1 | 2 | 3}
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip igmp version 2
DXS-3600-32S(config-if)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the value of robustness variable, ranging 1 to 7.
The default value is 2.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The Robustness Variable allows tuning for the expected packet loss on a network. If
a network is expected to be lossy, the Robustness Variable may be increased. IGMP
is robust to (Robustness Variable - 1) packet losses.
Use the show ip igmp interface command to verify your setting.
This example shows how to set the value of robustness variable to 3 on the interface
VLAN 1.
Specifies three version numbers, ranging 1 to 3.
The default value is 3.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
Use this command to globally configure the IGMP version. We recommend that all
devices on the subnet support the same IGMP version.
Use the show ip igmp interface command to verify your setting.
This example shows how to set the version number to 2 on the interface VLAN 1:.
260