D-Link DXS-3600-16S Manual page 665

72-8 route-target
This command is used to add one route target of a VRF. Use the no form of this command to remove one route target.
route-target {import | export | both} route-target
no route-target {import | export | both} route-target
Parameters
import
export
both
route-target
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# ip vrf VPN-A
DXS-3600-32S(config-vrf)# route-target import 100:1
DXS-3600-32S(config-vrf)# route-target export 100:1
72-9 show ip vrf
This command is used to display the VRF settings.
show ip vrf [{details | interfaces}] [vrf-name]
Parameters
details
interfaces
vrf-name
N/A
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies to add an import route target to import routing information from the target
VPN extended community.
Specifies to add an export route target to export routing information to the target VPN
extended community.
Specifies to add both an import route target and an export route target.
Specifies the value of the route target.
By default, no route target is specified for one VRF.
VRF Configuration Mode.
Level: 15.
This command is used to add a route target to one VRF. One VRF can have multiple
route targets.
Use the command show ip vrf detail to check the settings.
This example shows how to create a VRF instance VPN-A and add an import and
export target.
(Optional) Specifies to show detailed information about one or more VRFs.
(Optional) Specifies to show interfaces associated with one or more VRFs.
(Optional) Specifies to show information associated with one VRF.
Specifies to display brief information about all VRF instances.
None.
Privileged Mode.
Level: 15
This command is used to check the settings of VRF instances.
657