D-Link DXS-3600-16S Manual page 448

Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-preference default 100
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)# route-preference vrf VPN-A default 90
46-3 route-preference static
This command is used to set the preference of the static route. Use no form of this command to restore to the default
setting.
route-preference [vrf vrf-name] static value
no route-preference [vrf vrf-name] static
Parameters
vrf vrf-name
value
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-preference static 50
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-preference vrf VPN-A static 60
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 8
This command sets the preference of static default routes.
Among the different type default routes, the one with the lowest preference will be
established as the active route. If that route has been found failed, then this route will
be automatically deactivated and the route with the next lower preference will be the
active route.
Users can verify the settings by entering the show ip route-preference command.
This example shows how to set the preference of the static default route to 100.
This example shows how to set the preference of static default route to 90 in VRF
VPN-A:
(Optional) Specifies to set the route preference of VRF routing table.
Specifies the preference of the static route. The value range is 1-999.
The default value of the static default route's preference is 60.
Global Configuration Mode.
Level: 8
Among the different type routes with same destination network address, the one with
the lowest preference will be established as the active route. If that route has been
found failed, then this route will be automatically deactivated and the route with the
next lower preference will be the active route.
Users can verify the settings by entering the show ip route-preference command.
This example shows how to set the preference of static route to 50.
This example shows how to set the preference of static route to 60 in VRF VPN-A.
440