Traffic Segmentation Commands - D-Link DXS-3600-16S Manual

Traffic Segmentation Commands

64-1 switchport protected unidirectional
This command is used to enable the interface isolated to a specified interface list for unidirectional protected. Use the
no form of the command to disable the interface isolated to a specified interface list.
switchport protected unidirectional {interface-type interface-list}
no switchport protected unidirectional [interface-type interface-list]
Parameters
interface-type
interface-list
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#switchport protected unidirectional tenGigabitEthernet 1/0/2-1/0/6
Success
DXS-3600-32S(config-if)#
64-2 show protected-ports
This command is used to display the switch port's protected configuration information.
show protected-ports interface interface-id
Parameters
interface interface-id
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the interface type, such as fastEthernet, gigabitEthernet and
tenGigabitEthernet.
Specifies the interface list.
The main interface is not isolated.
Interface Configuration Mode.
Level: 15
After the interface is isolated to a specified interface, the interface can not switch on
L2 and route on L3 to the specified interface. But the specified interface to it has no
limit.
If not specified, all interfaces will be included.
Use the show protected-ports command to display unidirectional configuration.
This example shows how to enable the port 1 isolated to port 2-6.
Displays the specified interface's unidirectional isolated information.
None.
Privileged Mode.
Level: 15
This command is used to display the switch port's protected configuration
information.
599