D-Link DXS-3600-16S Manual page 629

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface GigabitEthernet 1/0/1
DXS-3600-32S(config-if)#no xconnect vpls vpls100
DXS-3600-32S(config-if)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface GigabitEthernet 1/0/1
DXS-3600-32S(config)#encapsulation dot1q 100
DXS-3600-32S(config-subif)#no xconnect vpls vpls100
DXS-3600-32S(config-subif)#
67-8 show vpls
This command is used to display VPLS information.
show vpls [VPLS-NAME] [detail]
Parameters
VPLS-NAME
detail
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show vpls
VPLS Name
--------------------------------
vpls100
vpls101
vpls102
vpls103
vpls104
vpls105
vpls106
vpls107
Total Entries: 8
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to delete a local AC, which is an Ethernet-based AC and
the Ethernet port is 1/0/1, from a VPLS named vpls100.
This example shows how to delete a local AC, which is an Ethernet VLAN-based AC,
the Ethernet port is 1/0/1, and VLAN is 100, from a VPLS named vpls100.
(Optional) Specifies the VPLS name. This name can be up to 32 characters long.
(Optional) Specifies to display detailed VPLS information.
None.
EXEC Mode.
Level: 3.
This command is used to display VPLS information.
This example shows how to display all VPLS information.
VPLS ID
----------
100
101
102
103
104
105
106
107
Peers/ACs Oper Status
--------- -----------
3/1 Up
3/1 Up
3/1 Up
3/1 Up
3/1 Up
3/1 Up
3/1 Up
3/1 Down
621