D-Link DXS-3600-16S Manual page 552

55-8 snmp-server user
This command is used to configure a new user to a Simple Network Management Protocol (SNMP) group. Use the no
form of this command to remove a user from an SNMP group.
snmp-server user USER-NAME GROUP-NAME {v1 | v2c | v3 [encrypted] [auth {md5 | sha} AUTH-
PASSWORD] [priv des56 PRIV-PASSWORD]}
no snmp-server user USER-NAME
Parameters
USER-NAME
GROUP-NAME
v1
v2c
v3
encrypted
auth
md5
sha
AUTH-PASSWORD
des56
PRIV-PASSWORD
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#snmp-server user test public v1
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no snmp-server user test
DXS-3600-32S(config)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name of the user on the host that connects to the agent. The valid
length is 1 to 32 characters. The syntax is general string that does not allow space.
Specifies the name of the group to which the user belongs. The valid length is 1 to 32
characters. The syntax is general string that does not allow space.
Specifies that the SNMPv1 security model should be used.
Specifies that the SNMPv2c security model should be used.
Specifies that the SNMPv3 security model should be used. Allows the use of the
encrypted and or auth keywords.
(Optional) Specifies whether the password appears in encrypted format (a series of
digits, masking the true characters of the string).
(Optional) Specifies which authentication level should be used.
Specifies the HMAC-MD5-96 authentication level.
Specifies the HMAC-SHA-96 authentication level.
Specifies the password used for authentication.
Specifies the 56-bit DES algorithm for encryption.
Specifies the password used for privacy.
There is one user in default as following:
User Name: initial
Engine ID: 800000ab03000102030400
Storage-Type: nonVolatile
Security Level:
Auth Protocol: None
Priv Protocol: None
Group-Name: initial
Global Configuration Mode.
Level: 12
Use this command to create an SNMP user. The group to which this user belongs
must be created first. If this user belongs to a V3 group, then the password used for
authentication and encryption needs to be defined.
This example shows how to create an SNMP user called test in the SNMPv1 group
public.
This example shows how to remove the SNMP user called test.
544