Show Ip Ospf Area - D-Link xStack DGS-3620 Series Reference Manual

DGS-3620 m/ mSW Rls. 1.02.000

11-25 show ip ospf area

show ip ospf area [AREA-ID] [vrf VRF-NAME]
Syntax Description
AREA-ID
vrf VRF-NAME
Default
Command Mode
Usage Guideline
Example
Switch# show ip ospf area
OSPF Area Settings
Area ID Type
--------- ------ ----------------------- ----------------- ---------
0.0.0.0 Normal None
0.0.0.1 Stub
0.0.0.2 NSSA
Switch#
Field
Area ID
Type
Stub Import Summary LSA
Stub Default Cost
Translate
CLI Reference Guide
Use this command to show general information about OSPF areas.
(Optional) Show detail information about the specified area.
(Optional) Specifies to show area information about the OSPF VRF instance.
None.
Privileged mode
This command is used to show OSPF areas information. When the area ID is
specified, the detail information about this area will be displayed.
To check OSPF areas settings:
Stub Import Summary LSA Stub Default Cost Translate
Enabled
Enabled
Description
Identifier of area. ID 0.0.0.0 is backbone area.
Type of area. It could be normal, stub or NSSA.
Whether to prohibit summary routes advertised into the area. It is only
for stub or NSSA area. It is specified with the command area stub or
area nssa.
The cost for the default summary route used for a stub or NSSA area.
It is specified with the command area default-cost.
Whether on NSSA area leak the type-7 LSA outside to other areas. It
is only for NSSA area and specified with the command area nssa.
None
1
0
show ip ospf area
None
None
Disabled
353