D-Link DXS-3600-16S Manual page 88

Parameters
vrf VRF-NAME
all
IP-ADDRESS
AS-NUMBER
soft
in
prefix-filter
out
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#clear ip bgp vrf VPN-A all soft in
DXS-3600-32S#
7-24 clear ip bgp vpnv4
This command is used to reset BGP connections using a soft reset for IPv4 VPN address family sessions.
clear ip bgp vpnv4 unicast {all | IP-ADDRESS } [soft [{in [prefix-filter] | out}]]
Parameters
all
IP-ADDRESS
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the VRF name.
Specifies to reset all BGP sessions in the IPv4 VRF address family.
Specifies to only reset the BGP neighbor with the IP address in the VRF address
family.
Specifies to only reset the BGP neighbor with the AS number in the VRF address
family.
(Optional) Specifies a soft reset. The session is not torn down.
(Optional) Specifies an inbound reset. If neither the in nor out parameter is
specified, both the inbound and outbound sessions are reset.
(Optional) Clears the existing outbound route filter (ORF) prefix list to trigger a new
route refresh or soft reconfiguration, which updates the ORF prefix list.
(Optional) Specifies an outbound reset. If neither the in nor out parameters is
specified, both inbound and outbound sessions are reset.
None.
Privileged Mode.
Level: 8. (EI Mode Only Command)
This command can be used to initiate a hard reset or soft reset of BGP neighbor
sessions.
If a hard reset is applied to the inbound session, the inbound session will be torn
down and the local inbound routing table and the remote outbound routing table will
be cleared.
If a soft reset is applied to the inbound session, the session will not be rebuilt but the
local inbound routing table will be cleared and needs to be rebuilt.
If a soft reset inbound is enabled, then the routing table can be rebuilt based on the
stored route updates information. If a soft reset inbound is disabled, then the local
router will send the route refresh request to the neighbor to ask for the route refresh.
When the inbound session is soft reset with the prefix filter option, and the capability
orf prefix-list is enabled in the send direction, then the local BGP will send 'clear the
routing table', and notify the remote neighbor for the prefix filter.
This command can only take effect for the sessions in VRF address family.
In the following example, a soft reset is initiated for the inbound session for all
neighbors those have been created in the view of vrf and the outbound session is
unaffected.
Specifies to reset all BGP sessions in VPN address family.
Specifies to only reset the BGP neighbor with the IP address.
80