D-Link DXS-3600-16S Manual page 376

38-39 show mpls ldp neighbor password
This command is used to display the LDP neighbor password.
show mpls ldp neighbor password
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show mpls ldp neighbor password
Neighbor Password
----------- ----------
202.11.1.1 123456
192.1.1.1 abcd
Total Entries : 2
DXS-3600-32S#
38-40 ping lsp
This command is used to check the connectivity of the LSP for a specified FEC.
ping lsp NETWORK-PREFIX/PREFIX-LENGTH [times VALUE | timeout SECONDS]
Parameters
NETWORK-PREFIX/
PREFIX-LENGTH
times VALUE
timeout SECONDS
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
None.
EXEC Mode.
Level: 3.
This command is used to display the LDP neighbor password.
This example shows how to display the LDP neighbor password.
Specifies the IPv4 prefix FEC which the LSP connectivity will check.
Specifies the number of times to resend the same packet. The value range is 1-255
and the default value of times is 4.
Specifies the timeout interval in seconds for an MPLS request packet. The value
range is 1-99 seconds and the default value is 2 seconds.
None.
EXEC Mode.
Level: 3.
This command is used to check the connectivity of the LSP for a specified FEC. The
FEC can be an IP prefix. If there is no LSP for the specified FEC, the "Destination
unreachable" message will be displayed. Otherwise, MPLS echo request messages
will be sent out to along with the LSP of the specified FEC.
If the egress LSR receives the request message, it will reply to the request message
sender with an MPLS echo reply message. If the sender cannot receive replies
before the timeout, the "Request time out" message will be displayed.
368