Debug Ip Ospf Show Redistribution - D-Link DXS-3600-16S Manual

debug ip ospf show request-list
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip ospf show request-list
OSPF Request List:
*Area 0.0.0.0:
Circuit: 1.1.1.1
Neighbor: 90.2.0.1
LSID: 192.194.134.0
LSID: 192.194.135.0
LSID: 192.194.136.0
LSID: 192.194.137.0
LSID: 192.194.138.0
DXS-3600-32S#

40-47 debug ip ospf show redistribution

This command is used to display the current internal OSPF redistribution list.
debug ip ospf show redistribution
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#debug ip ospf show redistribution
OSPF Redistribution List:
IP
------------------
1.1.1.0/24
OSPF ASE Table:
IP
------------------
1.1.1.0/24
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
None.
None.
Privileged EXEC Mode.
Level: 15. (EI Mode Only Command)
Use this command to check the information about LSAs OSPF is requesting to
neighbors.
This example shows displays the current requested LSA.
IP: 1.1.1.2
RTID: 90.2.0.1 Type 257
RTID: 90.2.0.1 Type 257
RTID: 90.2.0.1 Type 257
RTID: 90.2.0.1 Type 257
RTID: 90.2.0.1 Type 257
None.
None.
Privileged EXEC Mode.
Level: 15. (EI Mode Only Command)
Use this command to check the information about the external route imported into
OSPF.
This example displays the external routes imported into OSPF.
Nexthop State Type Tag
--------------- ----- ---- ---------------
0.0.0.0 ON
Nexthop State Type Tag
--------------- ----- ---- ---------------
0.0.0.0 ON
Seq 0x8000002f
Seq 0x8000002f
Seq 0x8000002f
Seq 0x8000002f
Seq 0x8000002f
2 0.0.0.0
2 0.0.0.0
415