D-Link DXS-3600-16S Manual page 568

Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree mode rstp
Success
DXS-3600-32S(config)#
12 2000-02-15 00:46:00 INFO(6) Spanning Tree version change (new version:RSTP
)
DXS-3600-32S(config)#
57-7 spanning-tree mst configure
This command is used to enter the MST configuration mode in the global configuration mode and configure the MSTP
region. Use the no form of the command to restore all parameters (name, revision, vlan map) to the default values.
spanning-tree mst configure
no spanning-tree mst configure
Parameters
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#spanning-tree mst configure
Success
DXS-3600-32S(config-mst)#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
The default mode is RSTP.
Global Configuration Mode.
Level: 8
If mode is configured as STP or RSTP, all currently running MSTP instances will be
cancelled automatically.
If the newly configured mode is changed from the previous one, the spanning-tree
state machine will restart again, therefore all of the stable spanning-tree port states
will transit into discarding states.
This example shows how to configure the running version of STP module to RSTP.
None.
By default, all VLANs are mapped to the CIST (instance 0), name is 'bridge mac',
and the revision is 0.
Global Configuration Mode.
Level: 3
The MST configuration consists of three main parameters:
• Instance VLAN mapping - See the instance command
• Region name - See the name (MST configuration mode) command
• Configuration revision number - See the revision (MST configuration mode)
command
The exit command is used to leave MST configuration mode.
This example shows how to enter the MST configuration mode in the global
configuration.
560