D-Link DXS-3600-16S Manual page 167

Command Default Level
Usage Guideline
Example
DXS-3600-32S#show ip extcommunity-list
Extended Community List Name:
-----------------------------------------------
Type : Expanded
permit : _23
Total Filter Entries: 1
Extended Community List Name:
-----------------------------------------------
Type : Standard
permit :RT 1:1
SoO 1.1.1.1:1
permit :SoO 2:3 3.2.1.1:10
Total Filter Entries: 2
Total Extended Community-list Count:2
DXS-3600-32S#
Display Parameters
Extended Community List
Name
Type
Standard
Expanded
permit
deny
Total Filter Entries
Total Extended Community-
list Count
7-93 synchronization
This command is used to enable the synchronization between BGP and your Interior Gateway Protocol (IGP) system.
To enable the router to advertise a network route without waiting for the IGP, use the no form of this command.
synchronization
no synchronization
Parameters
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 3. (EI Mode Only Command)
If no keyword is specified, this command will display all extcommunity lists. The
extcommunity list name can be specified and it is useful for filtering the output of this
command and verifying a single named extended community list.
The following example displays the configuration of extended community-lists.
e1
s1
Description
Name of this extcommunity list.
Type of this community list.
Indicates that this entry is a standard extcommunity list with rt or soo value.
Indicates that this entry is an expanded extcommunity list with a regular expression.
Routes with extcommunity attributes match the entry will be accepted.
Routes with extcommunity attributes match the entry will be rejected.
Total number of entries of a specifically extcommunity list.
Total numbers of the extcommunity lists.
None.
This command is disabled by default.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
159