D-Link DXS-3600-16S Manual page 625

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#vpls-id 100
DXS-3600-32S(config-vpls)#
67-3 service-type
This command is used to set the type of emulated service in a VPLS.
service-type {raw | tagged}
Parameters
raw
tagged
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vpls vpls100
DXS-3600-32S(config-vpls)#service-type raw
DXS-3600-32S(config-vpls)#
67-4 mtu
This command is used to set local AC link MTU of a VPLS.
mtu <VALUE 0-65535>
Parameters
VALUE 0-65535
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to set the VPLS ID of a VPLS to 100.
Specifies the service type is Ethernet-raw mode in a VPLS. It means the
encapsulation of all pseudowires in the VPLS is Ethernet-raw mode.
Specifies the service type is Ethernet-tagged mode in a VPLS. It means the
encapsulation of all pseudowires in the VPLS is Ethernet-tagged mode.
Ethernet-tagged mode.
VPLS Configuration Mode.
Level: 15.
This command is used to set the type of emulated service in a VPLS in VPLS
configuration mode. All pseudowires of a VPLS should have same encapsulation as
the type of emulated service in the VPLS. The service type of a VPLS can be
modified only when there is no pseudowire existed in this VPLS.
This example shows how to set the service type of a VPLS to Ethernet-raw mode.
Specifies the local AC link MTU of a VPLS that will be advertised to remote peers in
this VPLS. The MTU must be same at both local and remote sites. If not, the related
pseudowires will not communicate correctly with remote peers. If a user specifies teh
MTU as 0, the local MTU will not be advertised to remote peers in the VPLS.
Note: A user must ensure that the specified MTU is same as the real MTU of the
local AC link.
1500.
VPLS Configuration Mode.
Level: 15.
617