Vlan Filter - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S# show vlan access-map
VLAN access-map vlan-map 20
match mac address: 6710,6720,ext_mac,7760,
action: forward
DXS-3600-32S# configure terminal
DXS-3600-32S(config)# vlan access-map vlan-map 20
DXS-3600-32S(config-access-map)# action redirect tenGigabitEthernet 1/0/5
DXS-3600-32S(config-access-map)# end
DXS-3600-32S# show vlan access-map
VLAN access-map vlan-map 20
match mac address: 6710,6720,ext_mac,7760,
action: redirect tenGigabitEthernet 1/0/5
DXS-3600-32S#

3-26 vlan filter

This command is used to apply a hostmap in a VLAN. Use the no command to remove a hostmap from a VLAN.
vlan filter map_name vlan-list vlan_id
no vlan filter map_name vlan-list vlan_id
Parameters
map_name
vlan_id
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan filter vlan-map vlan-list 5
DXS-3600-32S(config)#end
DXS-3600-32S#show vlan filter
VLAN Map vlan-map
Configured on VLANs: 5
DXS-3600-32S#
3-27 show vlan access-map
This command is used to display the VLAN access-map configuration of the interface.
show vlan access-map [map_name]
Parameters
map_name
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the action attribute in the submap.
Specifies the name of the hostmap.
Specifies the VLAN ID used.
None.
Global Configuration Mode.
Level: 12
One VLAN Access Map can be applied to multiple VLANs.
One VLAN can bind with only one VLAN Access Map.
This example shows how to apply the hostmap 'vlan-map' to VLAN 5.
Specifies the name of the hostmap to be configured. The name can be up to 32
characters long.
38