Ip Pim Ssm - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim bsr-candidate vlan2 hash-mask-length 32 priority 10
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip pim bsr-candidate vlan2
DXS-3600-32S(config)#
47-11 ip pim old-register-checksum
This command is used to specify for which RP, the switch should calculate checksum include the data portion or not
when transmitting and receiving register messages. To restore the default setting, use no form of this command.
ip pim old-register-checksum rp-address RP-ADDRESS
no ip pim old-register-checksum rp-address RP-ADDRESS
Parameters
RP-ADDRESS
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#ip pim old-register-checksum rp-address 172.18.63.2
DXS-3600-32S(config)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#no ip pim old-register-checksum rp-address 172.18.63.2
DXS-3600-32S(config)#

47-12 ip pim ssm

This command is used to configure the SSM multicast group address range. Use the no form of the command to
disable PIM SSM.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to configure the PIM candidate BSR priority to be 10 and
hash mask length to be 32.
This example shows how to disable the function of BSR in 'vlan2'.
Specifies that the RP will expect to receive a register packet in which the checksum
will include the data portion or not.
The checksum in the register message to any RP doesn't include the data portion.
Global Configuration Mode.
Level: 8. (EI Mode Only Command)
This command is used to decide the checksum in register packet will include the
data portion or not. As defined in RFC 4601, the checksum for Registers is done only
on the first 8 bytes of the packet, including the PIM header and the next 4 bytes,
excluding the data packet portion. Some earlier PIM-SM routers calculate checksum
for register packet including data portion. This configuration makes our routers
communicate with those earlier routers smoothly. The default setting is not including
data portion.
To verify your configuration, use command show ip pim.
This example shows how to configure the checksum to include data for RP
172.18.63.2
This example shows how to delete the checksum to include RP 172.18.63.2
457