D-Link DXS-3600-16S Manual page 143

Display Parameters
Status codes
Origin codes
Network
From
Reuse
Path
Flaps
Duration
7-80 show ip bgp filter-list
This command is used to display routes that conform to a specified filter list.
show ip bgp filter-list [{all | rd ASN:NN | vrf VRF-NAME}] ACCESS-LIST-NAME
Parameters
all
rd ASN:NN
vrf VRF-NAME
ACCESS-LIST-NAME
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Description
Status of the table entry displayed at the beginning of each line. It can be one or
more of the following values:
s - The table entry is suppressed.
d - The table entry is damped.
h - The table entry is damped and has been withdrawn by the neighbor.
* - The table entry is valid.
> - The table entry is the best entry to use for that network.
i - The table entry was learned via an internal BGP (iBGP) session.
Origin of the table entry displayed at the end of each line. It can be one of the
following values:
i - Entry originated from an Interior Gateway Protocol (IGP) and was advertised
with a network router configuration command.
e - Entry originated from an Exterior Gateway Protocol (EGP).
? - Origin of the path is not clear. Usually, this is a router that is redistributed into
BGP from an IGP.
IP prefix with its mask length of the entry dampened.
The IP address of the peer advertised this route.
Time after which the route will be made available. Format is HH:MM:SS.
Autonomous system paths of route that is being dampened.
Number of times that the route has flapped.
Time since the router noticed the first flap. Format is HH:MM:SS.
(Optional) Specifies to display routes of all VPN and VRFs.
(Optional) Specifies to display routes with the specified Route Distinguisher. The
ASN:NN can be IP address:number or AS number:number.
(Optional) Specifies the VRF name. The length of the VRF-NAME is 12 characters.
Specifies the AS path access list name and only the routes match the AS path
access list are displayed. The maximum length is 16 characters.
None.
Privileged Mode.
Level: 3. (EI Mode Only Command)
Use this command to display routs which are match the filter list specified.
135