D-Link DXS-3600-16S Manual page 398

ip ospf hello-interval seconds
no ip ospf hello-interval
Parameters
seconds
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip ospf hello-interval 50
DXS-3600-32S(config-if)#
40-17 ip ospf message-digest-key
This command is used to configure the MD5 digest key for OSPF interface. Use the no command to delete the MD5
key.
ip ospf message-digest-key key-id md5 key
no ip ospf message-digest-key
Parameters
key-id
key
Default
Command Mode
Command Default Level
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the interval in seconds. The value range is 1 to 65535.
The default interval is 10 seconds.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
The hello-interval is advertised in the hello packets.
Configure the same hello-interval for all routers on a specific network. A shorter hello
interval ensures faster detection of topological changes but generates more routing
traffic and might cause routing instability.
Please note that the dead-interval can not be less than the hello-interval and must be
multiple times as hello-interval.
Users can verify the settings by entering the show ip ospf interface command.
This example shows how to set the hello-interval of System interface (VLAN 1) to 60
seconds.
Specifies a value for MD5 key identifier. The value range is 1 to 255.
Specifies up to 16 characters for the OSPF MD5 message digest key. The syntax is
general string that does not allow space.
By default no MD5 key is configured.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
390