D-Link DXS-3600-16S Manual page 577

Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1
DXS-3600-32S(config-if)#spanning-tree tc-guard
Success
DXS-3600-32S(config-if)#
57-22 show spanning-tree
This command is used to display the global spanning-tree configurations.
show spanning-tree [summary | forward-time | hello-time | max-age | tx-hold-count | max-hops]
Parameters
summary
forward-time
hello-time
max-age
tx-hold-count
max-hops
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#show spanning-tree
StpVersion : RSTP
StpStatus : Disabled
BridgeMaxAge : 21
BridgeHelloTime : 1
BridgeForwardDelay : 16
MaxHops : 19
TxHoldCount : 5
DXS-3600-32S#
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Level: 8
Both of the physical port and port-channel interfaces are valid for this command.
This configuration will take effect on all the spanning-tree modes.
A Boolean value set by management. If TRUE causes the Port not to propagate
received topology changenotifications and topology changes to other Ports. This
parameter should be FALSE by default. If set it can cause temporary loss of
connectivity after changes in a spanning trees active topology as a result opersistent
incorrectly learned station location information. It is set by a network administrator to
prevent bridges external to a core region of the network, causing address flushing in
that region, possibly because those bridges are not under the full control of the
administrator or MAC_Operational for the attached LANs transitions frequently.
This example shows how to configure TCN filtering.
Displays the information on various instances of MSTP.
Displays the forward-time.
Displays the hello-time.
Displays the max-age.
Displays the tx-hold-count.
Displays the max_hops.
None.
EXEC Mode.
Level: 3
Show the Spanning-Tree global configuration.
This example shows how to display the global configuration of STP.
569