Virtual Router Redundancy Protocol (Vrrp) Commands - D-Link DXS-3600-16S Manual

Dxs-3600 series layer 2/3 managed 10gbe switch
Hide thumbs Also See for DXS-3600-16S:
Table of Contents

Advertisement

Virtual Router Redundancy Protocol (VRRP)
Commands
69-1 vrrp authentication
This command is used to enable VRRP authentication and set the password on an interface. Use the no form of this
command to remove the authentication.
vrrp authentication string
no vrrp authentication
Parameters
string
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#vrrp authentication test
DXS-3600-32S(config-if)#
69-2 vrrp critical-ip
This command is used to set the critical IP address of a virtual router. Use the no form of this command to remove the
critical IP address.
vrrp vrid critical-ip ip-address
no vrrp vrid critical-ip
Parameters
vrid
ip-address
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the plaintext authentication password (8 bytes).
By default no authentication is configured.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
This command is used to enable VRRP authentication on an interface. The
authentication is applied to all virtual routers on this interface.
The devices in the same VRRP group must have the same authentication password.
Use the command show vrrp to verify your settings.
This example shows how to configure one interface's VRRP authentication.
Specifies the virtual router identifier. The valid range is from 1 to 255.
Specifies the critical IP address.
By default, no critical IP address is configured.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
This command is used to set the critical IP address for one virtual router. If the critical
IP is configured on one virtual router, the virtual router can not be active when the
critical IP address is unreachable. The critical IP address is a valid host address and
must belong to one existing interface on switch.
Use command show vrrp to verify your settings.
632

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents