Open Shortest Path First (Ospf) Version 2 Commands - D-Link DXS-3600-16S Manual

Open Shortest Path First (OSPF) Version 2 Commands

40-1 area
This command is used to create an OSPF area. To remove an area, use the no form of this command.
area area-id
no area area-id
Parameters
area-id
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router ospf
DXS-3600-32S(config-router)#area 0.0.0.1
DXS-3600-32S(config-router)#
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router ospf
DXS-3600-32S(config-router)#no area 0.0.0.1
DXS-3600-32S(config-router)#
40-2 area default-cost
This command is used to specify the cost associated with the default summary route that will be automatically injected
to the stub area and no-so-stubby area (NSSA). Use the no command to restore to the default setting.
area area-id default-cost cost
no area area-id default-cost
Parameters
area-id
cost
Default
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the ID of the area. The ID should be specified as an IP address.
The backbone area (0.0.0.0) is created by default.
Router Configuration Mode.
Level: 8. (EI Mode Only Command)
The area created by this command is a normal area. Users can not create an existed
area.
Use the no form of this command to remove a specified OSPF area and its
configuration, including the removal of the area-based configuration commands,
such as area default-cost, area nssa. Users can not remove the backbone area.
There is a limitation about number of OSPF areas and it depends on project.
Users can verify the settings by entering the show ip ospf or show ip ospf area
command.
This example shows how to create an OSPF area with area ID 0.0.0.1.
This example shows how to remove the area 0.0.0.1.
Specifies the ID of the area. The ID should be specified as an IP address.
Specifies the cost for the default summary route used for a stub or NSSA area. The
range of value is 0~65535.
The default value is 1.
379