Timers Basic - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#show ip rip interface
RIP Interface Settings
Interface Name: vlan1
Interface Metric: 1
TX Mode: V1 Broadcast
Authentication: Enabled
Password for Authentication: 1234
Distribute List In: map1
Interface Name: vlan2
Interface Metric: 1
TX Mode: V1 Broadcast
Authentication: Disabled
Distribute List In: None
Total Entries : 2
DXS-3600-32S#
Example
DXS-3600-32S#show ip rip interface vrf VPN-A
RIP Interface Settings
Interface Name: ip100
Interface Metric: 1
TX Mode: V1 Broadcast
Authentication: Disabled
Total Entries : 1
DXS-3600-32S#
Display Parameters
Interface Name
IP Address
Interface Metric
Administrative State
TX Mode
RX Mode
Authentication
Password for Authentication The plain text password. It is specified with the ip rip authentication text-password
Distribute List In
Total Entries

52-15 timers basic

This command is used to configure RIP timers. Use the no form of this command to restore to the default value.
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to check the settings of all RIP interfaces.
This example shows how to check settings of all RIP interfaces in VRF VPN-A.
IP Address: 100.1.1.1/24 (Link Up)
Administrative State: Disabled
RX Mode: V1 or V2
Description
The name of RIP interfaces.
The IP address of RIP interfaces.
The metric used by RIP interfaces to send update.
Administrative state of RIP interfaces. It is specified with the network command.
The version of RIP packets sent on the interface. It is specified with the ip rip send
version command, the ip rip send enable command and the version command.
The version of RIP packets received on the interface. It is specified with the ip rip
receive version command, the ip rip receive enable command and the version
command.
The authentication type of RIP interfaces. It is specified with the ip rip
authentication mode command.
command.
Access list name used as distribute-list in list. It is specified with the distribute-list in
command.
The total value of RIP interfaces.
IP Address: 10.90.90.90/8 (Link Up)
Administrative State: Enabled
RX Mode: V1 or V2
IP Address: 172.18.1.1/24 (Link Down)
Administrative State: Disabled
RX Mode: V1 or V2
519