Ip Ospf Cost - D-Link DXS-3600-16S Manual

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#no ip ospf authentication
DXS-3600-32S(config-if)#
40-13 ip ospf authentication-key
This command is used to configure the plain text authentication key for an OSPF interface. Use the no command to
delete the plain text authentication key.
ip ospf authentication-key password
no ip ospf authentication-key
Parameters
password
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#interface vlan 1
DXS-3600-32S(config-if)#ip ospf authentication
DXS-3600-32S(config-if)#ip ospf authentication-key yourpass
DXS-3600-32S(config-if)#

40-14 ip ospf cost

This command is used to configure the cost of sending a packet on an OSPF interface. Use the no command to restore
to the default value.
ip ospf cost cost
no ip ospf cost
Parameters
cost
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
This example shows how to remove the authentication on System interface (VLAN
1).
Specifies up to 8 bytes for the plain text authentication key. The syntax is general
string that does not allow space.
By default no key is configured.
Interface Configuration Mode.
Level: 8. (EI Mode Only Command)
This command creates a password (key) that is inserted into the OSPF header when
the router originates routing protocol packets. Assign a separate password to each
network for different interfaces. Routers on the same network must use the same
password to be able to exchange OSPF routing data.
Use the ip ospf authentication command to enable authentication. Configure the
routers in the same routing domain with the same password.
Users can verify the settings by entering the show ip ospf interface command.
This example shows how to set the System interface (VLAN 1) authentication type to
simple password.
Specifies the OSPF interface cost. The value range is 1 to 65535.
388