D-Link DXS-3600-16S Manual page 11

Parameters
c
message
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#banner login #Enter Command Line Interface#
DXS-3600-32S(config)#end
DXS-3600-32S#logout
Enter Command Line Interface
User Access Verification
Username:
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#banner login #
LINE c banner-text c, where 'c' is a delimiting character
Enter Command Line Interface
#
DXS-3600-32S(config)#end
DXS-3600-32S#logout
Enter Command Line Interface
User Access Verification
Username:
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the separator of the login banner message, for example a hash sign (#).
The delimiting character is not allowed in the login banner message.
Enter the contents of the login banner, that will be displayed before the username
and password login prompts, here.
Displays the switch type and other contents defined by the system.
Global Configuration Mode
Level: 3
Follow the banner login command with one or more blank spaces and a delimiting
character of your choice. Enter one or more lines of text, terminating the message
with the second occurrence of the delimiting character. For example with a hash sign
(#) being the delimiting character, after inputting the delimiting character, press the
enter key, then the login banner contents can be typed. The delimiting character
need to be inputted then press enter to complete the type.
To reset the login banner contents to default, use the 'no banner login' command in
global configuration mode.
Note: The typed additional characters after the end delimiting character are invalid.
These characters will be discarded by the system. The delimiting character can not
be used in the text of login banner.
This example shows how to configure the login banner. The hash sign (#) is used as
the delimiting character. The starting delimiting character, banner contents and
ending delimiting character will be entered before pressing the first enter key.
This example shows how to configure the login banner. The hash sign (#) is used as
the delimiting character.
3