D-Link DXS-3600-16S Manual page 619

Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#vlan 100
DXS-3600-32S(config-vlan)#subnet-base 20.0.1.0/8
DXS-3600-32S(config-vlan)#subnet-base 192.0.1.0/8 priority 4
DXS-3600-32S(config-vlan)#subnet-base 3ffe:22:33:44::55/64
DXS-3600-32S(config-vlan)#
66-12 show vlan
This command is used to display the parameters for all configured VLANs or one VLAN (if the VLAN ID or name is
specified) on the switch.
show vlan [VLAN-ID [, | -] | interface [INTERFACE-ID [, | -]] | subnet-base | mac-base]
Parameters
VLAN-ID
interface
INTERFACE-ID
,
-
subnet-base
mac-base
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
In the following example, the user creates a subnet-based VLAN entry for VLAN
100, specifying the subnets 20.0.1.0/8, 192.0.1.0/8 and 3ffe:22:33:44::55/64.
(Optional) Displays information about a signal VLAN identified by VLAN ID number.
The VLAN ID range is 1 to 4094. Separate nonconsecutive VLAN-ID with a comma;
use a hyphen to designate a range of VLAN-ID.
(Optional) Displays the port PVID, ingress checking, acceptable frame type
information.
Specifies the port to display.
(Optional) Specifies a series of ports, or separate a range of ports from a previous
range. No space before and after the comma.
(Optional) Specifies a range of ports. No space before and after the hyphen.
(Optional) Displays the subnet-based VLAN related configuration.
(Optional) Displays the mac-based VLAN related configuration.
None.
EXEC Mode.
Level: 3
The user can use the show vlan command to display the current VLAN status. The
user can display the VLAN list using the show vlan command. The user can display
a specific VLAN entry by specifying a VLAN-ID. The user can use the show vlan
interface command to show port related VLAN information, such as port PVID,
ingress checking, and acceptable frame type information.
If no optional keywords are specified, all of the VLAN configurations will be
displayed.
611