D-Link DXS-3600-16S Manual page 532

53-2 match as-path
This command is used to add a match command to match a BGP autonomous system (AS) path access list. Use the
no form of this command to delete the match command with BGP autonomous system path access list.
match as-path ACCESS-LIST-NAME
no match as-path
Parameters
ACCESS-LIST-NAME
Default
Command Mode
Command Default Level
Usage Guideline
Example
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map rmap1 permit 10
DXS-3600-32S(config-route-map)#match as-path PATH_AC
DXS-3600-32S(config-route-map)#
53-3 match community
This command is used to add a match command to match a Border Gateway Protocol (BGP) community list. Use the
no form of this command to delete the match command with BGP community list.
match community COMMUNITY-LIST-NAME [exact]
no match community
Parameters
COMMUNITY-LIST-NAME
exact
Default
Command Mode
Command Default Level
Usage Guideline
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
Specifies the name of the path access list. The length is up to 16 characters.
None.
Route Map Configuration Mode.
Level: 8. (EI Mode Only Command)
Only one path access list is supported. If this command is executed with a different
path access list, the old one will be overwritten.
You can verify your settings by entering the show route-map command.
This example shows how to add a match clause to match AS path access list.
Specifies the name of BGP community list. The length is up to 16 characters.
(Optional) Specifies to match BGP community list exactly.
None.
Route Map Configuration Mode.
Level: 8. (EI Mode Only Command)
The BGP community list is created with the command ip community-list. If exact is
specified, the communities in the community list must be exactly same as the
communities of the route.
If exact is not specified, this command is matched as long as one community is
matched.
Only one community list is supported. If this command is executed with a different
community list, the old one will be overwritten.
You can verify your settings by entering the show route-map command.
524